Tidland Mark I and II Roll Savers

• 
• 
• 
• 

Save your crushed core with Tidland's Mark I or Mark II Roll Savers. These roll savers are designed to re-open crushed cores, allowing for shaft insertion on rolls that would otherwise be considered scrap material. The Roll Saver provides a return on your investment with its first use as the cost is comparable to that of a damaged roll, creating a positive impact on profit margins and warehouse space. Air shafts cannot be inserted into rolls with even with the slightest deformation, leaving damaged rolls useless. With a Tidland portable hydraulic Roll Saver, rolls can be salvaged.

Key Features

Easy to use
Fully transportable - lightweight design can be used virtually anywhere
Trouble-free operation - easy to operate hydraulics provide up to 4 tons of thrust, giving you fast results
Cost effective - return on your investment can occur with your first salvaged roll!

Specifications

	Mark I Roll Saver		Mark II Roll Saver
Core ID:	70 mm to 76 mm	2-3/4 inches to 3 inches	70 mm to 76 mm	2-3/4 inches to 3 inches
Penetration:	*915 mm	*36 inches	250 mm	10 inches
Weight (body only):	17 kg	37 lbs	N/A	N/A
Weight (with pump):	26 kg	57 lbs	9 kg	19 lbs
Hydraulic Pressure:	700 bar	10,150 psi	621 bar	9,000 psi
For Roll Diameters up to:	1.8 m	70 inches	1025 mm diameter, 902 mm width	45 inch diameter, 36 inch width
Expansion	Approximately 1/4 inch above nominal core

*For roll widths up to 1.8 m (70 inches), insert roll saver into each end of roll

Documents